Got Transmissions » Manual transmissions

ZFS6-40 Manual Transmissions for Sale.

Tranny Man — Wed, 10 Mar 2010 14:08:49 +0000

ZF Manual transmissions for sale

[/caption] The ZFS6-40 is a constant-mesh 6 speed fully synchronized manual transmission used in General Motors vehicles. The design incorporates an input/main shaft, a countershaft, and the output/main shaft. The input shaft and main shaft are located on the same axis. The counter shaft is on a parallel [...]

Nissan 300ZX Clutch and Manual Transmission/s.

Tranny Man — Wed, 10 Feb 2010 14:22:53 +0000

Manual Transmissions for Sale

[/caption] The clutch in a 300ZX is your standard everyday clutch, nothing special. All non-turbos and 84-86 turbos have 240mm Nissan clutches. The 87-89 Turbos have 250mm Nissan clutches. All are hydraulically operated in the normal fashion. If you are going to replace your clutch setup, buy [...]

Make Your Clutch and Manual Transmissions Last Longer.

Tranny Man — Sat, 06 Feb 2010 13:29:50 +0000

Learning to drive manual transmissions can instill a lot of anxiety. Everyone thinks it is so hard to do and that they will be so embarrassed in front of other people while learning to drive a stick shift. It is mildly challenging, but worth the anxiety it creates? No. Basically, the car will not become [...]

Manual Transmission Gears Made Stronger..

Tranny Man — Fri, 29 Jan 2010 13:38:21 +0000

Manual Transmissions Gears

[/caption] Awesome. This is the way manual transmission gears and gears in general were made before mass production. The methods are similar, but nowadays we use CNC, computer numerically controlled equipment to get the job done faster and with consistent accuracy. This however is the way [...]

Manual Transmissions: Toyota Tacoma Transmissions

Tranny Man — Fri, 04 Dec 2009 13:43:12 +0000

Question: I have a 1996 Tacoma that I bought new. In the intervening time, I’ve put close to 220,000 miles on it. Around 4-5 years ago, 1st and second gear began popping out especially during warm-up. Fearing that the repair for the problem might be extremely costly, I put off the inevitable for several years.The [...]

Manual Transmissions: PT Crusier Transmissions

Tranny Man — Fri, 27 Nov 2009 13:43:03 +0000

2001 PT Cruiser with a 2.4 L 4 cylinder engine. Has one of the 5 speed PT manual transmissions . Question: I have a standard, 5-speed transmission and cannot shift into reverse gear; what could be the problem(s)? Possibilities: Without being able to examine the car myself, I can only make suggestions. The bottom line in any [...]

Chevy Transmissions: Muncie 4 Speed M22 Rockcrusher..

Tranny Man — Tue, 24 Nov 2009 15:59:50 +0000

Chevy Transmissions

[/caption] “Where Our Customers Send Their Friends” Chevy Transmissions: Muncie M22 “Rock Crusher 4 Speeds were made From 1965 TO 1974: The most popular transmission of it’s time for high performance cars built for Chevrolet and all performance oriented G.M cars. They have the same gear ratios as the legendary M21 but [...]

Manual Transmissions Operate Better With The Right Lubricant

Tranny Man — Wed, 04 Nov 2009 14:57:21 +0000

Manual Transmissions For Sale

[/caption] One of the problems that occurs with manual transmissions in specific, is the lack of knowledge in what type of lubrication to use. For instance many people notice their cars or trucks are ’sticky’ or ‘hard’ to shift when it is cold out. On the opposite end, when [...]

Manual Transmissions for Sale at Wholesale Cost..

Tranny Man — Tue, 03 Nov 2009 21:21:01 +0000

Contrary to popular belief, modern manual transmissions are equally as complicated as an automatic transmission. We call modern transmissions “constant mesh transmissions”. Examing the picture below:

Manual Transmissions For Sale

[/caption] We can see how the gears are meshed together all the time. Which is why we call them ‘constant mesh’. There is no [...]

Chrysler 5 Speed Manual Transmissions for sale cheap..

Tranny Man — Thu, 17 Sep 2009 14:15:30 +0000

There were a number of Chrysler five-speed manual transmissions used in EEK cars. Some, such as the A-568, were assembled by Getrag, but were actually designed by Chrysler (though they are commonly called “Getrag” transmissions). These were generally used in more demanding (turbo) applications. (Information source: 1987 service manual). Others were assembled by Chrysler itself. One [...]